Klark Teknik DN100 DiBox aktivní

KlarkTeknik DN100

The KLARK TEKNIK DN100 Single Channel Active Direct Injection Box is designed to provide an extended dynamic range, lower noise floor and all the world-class audio performance you’d expect from KLARK TEKNIK. The DN100 is built to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing.
The DN100 was designed for professional applications where +48 V phantom power is a standard feature on all mixing consoles. Some DI boxes offer both phantom power and 9V battery operation, however the design compromises required to support both power sources means that the audio performance is degraded. Most notably the amount of signal headroom available. The clip point of the DN100 is significantly higher than many professional active DI boxes and can provide +10 dBu into a 2 kΩ load. This higher clipping point means that much higher level input signals can be accommodated without the need for switching in an attenuating pad. Correspondingly the DN100 only requires a single -30 dB pad for use when connecting directly to instrument amplifier outputs.

Specifications:

Input:
• Type: active electronic, balanced or unbalanced
• Impedance: 1M Ω nominal, balanced or unbalanced (jack connectors) 20K Ω (XLR input only)
• Connectors: 2 quarter inch jacks and 3-pin XLR linked in parallel
• Maxmum level: 30dBu
• Attenuator: 30dB switchable

Output:
• Type: Transformer Isolated, balanced
• Impedance: 300 Ω
• Connector: 3 pin XLR
• Max. Level: 10dBu with load >2k Ω
• Min. load: 600 Ω

Performance:
• Noise: -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
• Frequency response: +0.5/-1dB 20Hz to 20kHz
• Distortion (THD+N) output: <0.01% @ 1kHz, +4dBu

Power Requirement:
• Voltage: +48V Phantom *
• Current consumption: <10mA

Dimensions:
• Length: 142mm (5.6 inch)
• Width: 106mm (4.2 inch)
• Height: 60mm (2.35 inch)
• Weight: <1kg