EarthQuaker Devices Night Wire V2 kytarový efekt

The brand new Night Wire is an option rich harmonic tremolo pedal. What is harmonic tremolo? In short, the signal is split into high pass and low pass filters, then modulated with an LFO that is split 180 degrees. The Night Wire takes the traditional harmonic tremolo a few steps further by allowing the center point of both filters to be adjusted for different tones. The filter frequency has three modes: Manual, LFO and Attack. In Manual mode, the center point can be set to a fixed position with the frequency control. In LFO mode, the filters are continuously swept and the frequency control adjusts the speed. In Attack mode, the filters are dynamically swept according to pick attack and the frequency control acts as a range control, much like a standard envelope filter. The tremolo section has two modes, Manual and Attack. In Manual mode, the speed of the tremolo is governed by where the rate control is set. In Attack mode the speed is controlled by pick attack and the rate controls the sensitivity - the harder you pick, the faster the rate and vice-versa. It can be activated in standard latching operation or in momentary operation, by just holding the footswitch down for as long as you’d use the effect. It also features an improved circuitry for lower noise, a cut/boost volume control, true bypass, relay based “soft touch” switching and is hand made in Ohio, USA.

- harmonic tremolo effects pedal
- separate high pass and low pass filters
- LFO split 180 degrees
- the center point of both filters can be adjusted for different tones
- footswitch works as momentary or latching switch
- improved circuitry for lower noise
- true bypass
-
- controls for Level, Depth, Rate and Frequency
- filter frequency toggle switch with three modes Manual, LFO and Attack
- tremolo section toggle switch with two modes Manual and Attack
- bypass footswitch
- silent relay-based soft touch switching
- status LED
- metal housing
- 6.3 mm mono IN/OUT jacks
- power supply optional 9V DC adapter 2.1 mm x 5.5 mm barrel plug, polarity (-) center
- battery operation not supported
- dimensions (D x W x H) 117 mm x 64 mm x 57 mm
- current draw 30 mA
- hand-made in USA